so my provari may have done something weird....

[craftmath]

I use boge lr carto's with a tank setup on a daily basis with my provari around 4.2 volts. A guy was curious what ohms his $3 clearomizer was so I said, "Let me throw it on my Provari and check it for ya". I checked it on the Provari and it showed up as 3ohms. I then popped my tank right back on and the provari FRIED the cartomizer when I went to vape it. I'm pretty sure the carto was wet as I was just vaping it before testing the ohms for my buddy. I checked the voltage and it was still 4.2, but it definitely sounded and made the cartomizer taste as if it was set to 6v. Any freak occurences like that for any of you?

 

[tobarger]

If it is a coincidence that the cartomizer popped at that moment just to make you wonder what the hell is going on, then I would be very angry with that cartomizer. I might even slap it around a little bit. Unfortunately, from my experience with fixing stuff in general, I have noticed that coincidences like this occur more often than I care for. Therefore, my opinion is that it very well could be just a coincidence.

 

[79Silo]

If it is a coincidence that the cartomizer popped at that moment just to make you wonder what the hell is going on, then I would be very angry with that cartomizer. I might even slap it around a little bit. Unfortunately, from my experience with fixing stuff in general, I have noticed that coincidences like this occur more often than I care for. Therefore, my opinion is that it very well could be just a coincidence.

i fully agree

 

[craftmath]

*just suplexed the carto*.... that's what you get for f'ing with my head.