Did you try this ? , when screwing down the ceramic housing make sure you screw it so that the oring on the positive post is creating a good seal against base .Yes Imeo, I've seen your non-leaking big mode before.This time around though, you're using the V2 - that's cheating!
When you say to use 3.5mm wick, is that what I got? I got all my wick from Bruce shortly after the V1 Ody came out, and I now see he has 3.5 and 3.0 but I don't remember what size I got - I am sure he only had one size at the time though.
Regardless, I just can't get mine to not leak...I'm sure it's user error, no fault of your wonderful design. I even get gurgling and some small leakage in short mode from time to time.
I haven't messed with it since posting last, but I think I'm gonna try my hand at a dual coil tonight...in BIG mode. I'll report back!
Some advice from the GG pros
- Thread starter Supacrazyguy
- Start date
- th_trl_thread_readers 0
- Status
When I try to put the neg wire just down the slot, I have connection issues. I've also tried wrapping the neg wire around the wick, then going down the slot, this way seems to provide a better connection. But either way, I still get leaking.
I'm gonna try again tonight - will report back!
Yup, I'm getting a good seal there. My leaking is from the air hole in the center post - obviously a problem with over wicking.
I know my post might sound dumb but it happened to me today and solved it in 2 mins by doing this . anyways , I hope it works out for you
- Status
