Steve...... do you think the O-ring is too big? Does it not fit properly when you put it in place? Trying to figure out why this is happening.....
Last edited:
For all intents and purposes it functions just like a carto tank, when you toke on it it decrease atmospheric pressure on the on the inside so since tank pressure is higher the juice goes in. If not in a vacuum all the juice above the coil would leak out, slowly because it has to travel through the wick but leak just the same.Steve, with the tank top off, and the o-ring out screw on the collar and look in there from the tank side and see if there is enough space left for the o-ring. I'm thinking there's a better chance that the tank top wasn't machined far enough inside than for the o-ring to be too big, but we shall see I guess when you get your o-rings
With the o-ring out the lid screws flush as it should I believe. When I ordered my Terminator I ordered a replacement set of O-rings. Tried the replacement with the same results. I also just tried replacing the o-ring with one from a kit I have on hand. Ody spec.'s call for a 2X9 mm all I had was a 1.9 X 8.8mm. I'll see what that does. I'm not sure what else to try at this point.
Steve
Well if the o-ring fits perfectly in the tank top, OD, and fits perfectly on the stem, ID, then it sounds as if it is correct.
Now about your dry hits, you don't want the silica to fit too tightly in the side channels.
Are you wrapping your coil too tight and strangling the wick maybe? gotta ask
I had to quit smoking, I spent all my cigarette money on Vaping supplies.