Sorry if this is the wrong place

[Newbie sam]

Hi there I have the aspire e-ts some how I have burnt out 2 coils I would realy appreciate some help on how set up a new coil without getting that burnt taste

 

[Izan]

Hi Sam.


Are you priming the coils? - add a few drops directly to the coil before closing and filling the tank.
Are they authentic coils?
Have you cleaned to rest of the tank to remove any lingering burnt flavours?
What device are you using to power the Aspire?


Good luck
I

 

[Newbie sam]

I didn't put any directly in the coil I think one of them was a fake but I have genuin ones should be here today well I hope they are I purchised my new ones from cool vape I am using a 1100 vv evod twist bought from my local vape shop

 

[classwife]

Moved to Clearomizers from Rebuildable Atomizer Systems

 

[javarivanhans]

Yes, I prime by putting a drop down the hole and letting it sit for a few minutes, then taking few NO power dry puffs to prime the wicks some more. BUT condition the new coils by starting at your mods lowest setting and do several puffs, then going up 0.3watts at a time, puffing 3-5 times at each interval till you are at about 8-9watts. over 13 watts and you are getting into burn territory. If you start at high wattage, even if it tastes fine, you can not do this conditioning, its too late.

 

[Mr GRIMM]

I made that mistake with my kanger aerotank, not priming and jumping to high watts to fast... burn central. I'm still new so that's why I'm glad this forum exists.

 

[sparkky1]

You can start taking dry hits. A dry hit is when you take a pull from your clearomizer without activating the battery. The suction created will force the e-liquid into the coil’s wicking area and allows the wick to become saturated with e-liquid. Take around 5 dry hits, but do not exceed that amount. If you take more than 5 dry hits, you’re taking a chance of flooding your coil with e-liquid or sucking e-liquid into your mouth.