Stock RM2 O-Ring

[lissa5168]

My fumble-fingers lost my o-ring for my RM2 down the sink this morning. Grrrrrr.

I had some #7s from making charms back in the day here that someone had suggested were better, but I didn't like that as well. Does anyone know what size the o-ring is that comes with the RM2?

>^.^< Purred contentedly via Tapatalk

 

[jifjifjif]

You can always remove the P-trap from your sink and retrieve it. Hopefully, it didn't get flushed all the way through the drain pipe.

 

[Funk Dracula]

Really any o-ring that'll fit around the 510 connection, and squish down a bit to make a seal and give you the leeway to position your air hole where you want it will work. It's not an exact science/critical fit like a tank.

I use some spare o-rings from a old carto-tank. They were a bit thicker than the one that came with the RM2 and worked better for me. Got a whole little baggy full of 'em.

 

[nerak]

10mm X 12mm is the size.

 

[ltrainer]

I use the ones that come in the bottle cap.

 

[NicLiq]

When I was having trouble getting my coil to line up, a suggestion was to take the gasket off an old drip tip and put it on the post for the RM2 (instead of in the well).

 

[Filthy-Beast]

10mm X 12mm is the size.

I think you got and extra zero in there. 1mm x 12mm, I like the thicker one Rob sells as an option that is 1.5mm thick

 

[rabernet]

I think you got and extra zero in there. 1mm x 12mm, I like the thicker one Rob sells as an option that is 1.5mm thick

Bless her heart - she's having all sorts of trouble with numbers today!

 

[lissa5168]

Thanks, Karen! Just what I needed........picked some up at Lowe's after work. Yay!

>^.^< Purred contentedly via Tapatalk