Storm Clear Tank Mod frustration!

[greymattergirl]

I'm sorry if I'm not posting this in the correct place, I looked around but couldn't find anything I thought was suitable. My problem/question is..I just recieved my Storm Clear tank mod..and it LEAKS!! BAD!!! Does anyone know how this can be fixed? It vapes beautifuly, and I love it, but aside from having to drip constantly, I purchased it on the premise it wouldn't leak. I do have a message into Bruce, but haven't heard back yet, and the sooner I have it sorted the better. All it has on the end is a rubber stopper for the tip. Please help! Thanks in advance!

 

[WomanOfHeart]

Did you overfill it by any chance? I'm just reading the instructions on the site for these.

 

[greymattergirl]

No, def not. Maybe I'm confused..it doesn't leak unless turned almost upside down, AND the rubber stopper, is as far from secure as it gets. The smallest bump, and the whole rubber piece just slides right out. When they say it doesnt leak, does that mean only if you dont bump it or turn it upside down? Whats the point of it then?

 

[04 Raider Rider]

http://www.e-cigarette-forum.com/forum/clouds-vapor/147098-map-tank-mod-4.html

You might find some info there.Saw a few talking about leaks,cracks,etc.Hope he gets it worked out for you,but think I'll pass on these for a bit.

 

[floridamale]

If you go to the COV sight and look at the storm tank page there is instructions there for the proper way to fit the top grommet so it dose not leak

I''ll save you the time and post it here
Hope this helps
Instructions for use:

Fill your Storm Clear with juice to just below the ceramic cup and put the tip through the black ring, start it into the tube, attach the tip to the CE2 and work the rubber ring in.

If you do it in the order, it will fit snug. If you don't do it in this order, the black ring will go too far down over the cup.

You may see some leakage when you fill too high, the juice gets into the cup and flows down the tube to the atty connector. So don't overfill!