Stuffing my ipv mini.

[JonasDK]

Hi guys.

I have a confession to make. I over drip, constantly. And it gets quite messy sometimes.
I know, I know. It's a waste of juice. But I just can't seem to control my self
So the other day I was taking apart my ipv mini v2, to clean out any juice that might have gotten in there. And I noticed that there are quite a lot of empty space between the 510 and the battery tube.
So I was thinking that maybe I could put some cotton or tissue in there, to suck up any juice that might get in that way. But I was concerned that there might be some safety issues with that. Overheating or something like that.
What are your guys thoughts on that?

 

[classwife]

Moved to Variable Voltage APV Discussion from APV Discussion

 

[roxynoodle]

You might be a good candidate for a mech

I'm an oversquonker. I will stick to a Reo because I would ruin a regulated squonker!

 

[sando7]

nuttin like a good squonk!

personally i would not stuff anything inside the ipv that isn't supposed to be there.

 

[crxess]

Best to not add anything inside the mod. Better to pay attention. If 10 drops floods, use 8.
Check and adjust your RDA so the air holes are always to the side when in use. Top to bottom is a guarantied leak.

 

[3mg Meniere]

One of these $1.11 510 to 510 Adapter for E-Cigarette at FastTech - Worldwide Free Shipping is best for protecting your mod from juice drips.

 

[sando7]

meant respectfully, if your gonna use an adapter for jooze leaks you want it to be sealed (no hole in the 510 pin).
this one below is even 22mm wide...... the "Kepler"

$11.60 Kepler 510 Finned Heat Sink for Atomizers (3-Pack) 3-pack - 22mm diameter / aluminum + copper + SS at FastTech - Worldwide Free Shipping
you can also buy single versions listed bottom right on the pg.