Stupid question, but I have to ask..

[WilsonR]

I have the Nemesis clone. I didn't notice until I was doing some research on it that it has an adjustable airflow control right below where the atty attaches. What exactly is that for? You can see the holes towards the top in this picture

 

[jpcwon]

It's there in case you're running an atty that requires airflow from the 510 connection (like a Spheroid or a carto tank).....If you're using an atty that has its own airflow, then you don't need to worry about it.....

 

[anumber1]

Good to have if you are using an atomizer that draws its air through the 510 connection.

A protank comes to mind.

 

[MrPlink]

like the Chi You, it shows the age of the design since most people are moving away from attys that use that type of airflow.

 

[jpcwon]

I use 3 Spheroids that have 510 airflow that I run on my mechanical mods......the draw is a bit on the tight side, but they're great attys....A lot of people still run them and they show no signs of going away...

 

[WilsonR]

Ok..that make sense now. Thank you!!