Sub ohm on RSST?

[palmmute]

If you got it, please post your specs if you don't mind. .8 ohms would be ideal for me. I have .8 ribbon with a 3 wrap on 400 mesh but it's around 1.0-1.2 ohms.

Maybe my wick is too big but if the wick is too thin, the thing leaks out the top of the wick hole too easily.

 

[Rule62]

Typical set up, for me: 400 mesh. 90mm before rolling. I start the roll on a 1/16" drill bit; and then remove the bit to finish it up, and size it to the coil. Coil is 28ga kanthal A1, wrapped around a 7/64 drill bit. 4/3 wrap, .9Ω.
It looks like this:

 

[palmmute]

Thanks for tips Rule! I want to like your post but don't how to on the mobile app.

 

[pacman68]

Mine is also on 400 mesh around same diameter 90mm, 28ga kanthal A1, manually wrapped around mesh 2-3 times

 

[mullet]

I think this one measured in around .7 (was building 2 at the same time and forget which was which now)
1/8" SS wire rope with a small piece of 400 mesh under coil, 4 wrap of 26awg

 

[fanatic205]

A 3/4 wrap of 30ga kanthal will get you between .8-.9 ohms, and a 3/4 wrap of 28ga will hit around .6-.7.