Guys. Facing a problem now. My subtank mini can't screw on my sigelei mini. I thought its the pin problem, then I changed my derringer and screw it on and deringger works perfectly. Only my subtank mini cant screw. Its like the pin kept pushing it out. even if i tried to push in and screw also cannot. Anyone here knows whats going on?
Subtank Mini base couldn't screw on sigelei mini box mod
- Thread starter Kelvin Teh
- Start date
- th_trl_thread_readers 0
- Status
Do you mean the spring loaded 510 on the mod is pushing up the 510 pin of the subtank?
Sounds like maybe the Subtank would prefer a mod that doesn't have a spring loaded 510.
check your 510 thread, i had the same problem with subtank... some time later i can screw nothing on there
Last edited:
My DErringer works fine on my 510. So I assume its not my mod problem.
Recoiled it last night. Read 0.9 on my mod. Then I put some juice in my rba and burn it. Works well. So I refill the juice and screw the glass on. Suddenly it showed low res. Found it weird so I unscrew the whole tank and screw back in, that's when it refused to screw on my mod.
Sorry guys not sure if u guys understand. But that's what happened.
Recoiled it last night. Read 0.9 on my mod. Then I put some juice in my rba and burn it. Works well. So I refill the juice and screw the glass on. Suddenly it showed low res. Found it weird so I unscrew the whole tank and screw back in, that's when it refused to screw on my mod.
Sorry guys not sure if u guys understand. But that's what happened.
ahh ok, did you check the rba base, tight positive post
check your coil without rba barrel
check your coil without rba barrel
Managed to solve the problem by putting thread seal tape around tank thread and screw it down, no more jumping ohm and fire well but seems to be solving the problem temporarily only. Shop staff told me not to unscrew the base out anymore else need to seal it with new tape again.
Or should I get one heat sink adapter instead?
The heat sink adaptor can't hurt, and they're inexpensive.
I don't have a subtank, but can the 510 pin be removed on it? If so, try putting one or two 2 x 1 o rings on it, near the pin head. That should keep it from moving and touching the walls of the 510.
I don't have a subtank, but can the 510 pin be removed on it? If so, try putting one or two 2 x 1 o rings on it, near the pin head. That should keep it from moving and touching the walls of the 510.
- Status
Similar threads
