My first RBA just came in the mail, a DiD clone from RTDvapor.com. I sat down on the couch and used a Bic lighter to oxidize the mesh. Wrapped four or five coils, tested it with my mutimeter at 3.1ohms put it on my Provari and it checked out at 1.6ohms?? a little prodding and it was giving a nice even glow. Injected some juice tipped it to make sure the wick was working, slapped the top on and I'm vapin' my first try.
Flavor seems much cleaner than carto tanks I've been using, throat hits are very good at 3.7-4.1v, vaper is as good or better than the carto tanks as well.
(time warp)
Only two things that are a bit off for me. 1. the drip tip is quite loose. 2. The draw is a bit tight for my liking.
I've been vaping it for a couple hours now and it's wicking well.
Got the drip tip issue a bit better, took off the Oring and wrapped some thread in the groove. It is still a bit looser than I would like but good enough for now.
I think I'm going to pick up a glass tank from Ibtanked for it also, I dont like not knowing how much juice I have in it.
Flavor seems much cleaner than carto tanks I've been using, throat hits are very good at 3.7-4.1v, vaper is as good or better than the carto tanks as well.
(time warp)
Only two things that are a bit off for me. 1. the drip tip is quite loose. 2. The draw is a bit tight for my liking.
I've been vaping it for a couple hours now and it's wicking well.
Got the drip tip issue a bit better, took off the Oring and wrapped some thread in the groove. It is still a bit looser than I would like but good enough for now.
I think I'm going to pick up a glass tank from Ibtanked for it also, I dont like not knowing how much juice I have in it.
