Success!

[PoeDung]

Is their anything more satisfying than vaping on your first successful rebuild?

I finally built a successful replacement coil for my Protank 2 using cotton! Turned out to be 1.7ohm. Taste is about the same as a carto, doesn't seem like I'm getting the vapor I should, but I'm still happy!!

 

[Boiler]

My first coil was crooked and lopsided and vaped great!

 

[Sthur]

Congrats on the first rebuild. I make 1.8 ohm microcoils with 1/16 bit and cotton. I can run them at 7-8 watts no problem. Are you turning it up enough? My best vaping moment was my first coil build too.

 

[Ryedan]

My first coil was crooked and lopsided and vaped great!

LOL, Boiler, you made me think of my first vapeable build in my AGA-T. The coil was bent, lopsided, inside out and looked just plain awful, but it vaped and not too badly if I remember correctly. Of course then it started to short and that was that.

Good for you PoeDung! IMO if it tastes as good as a carto, you did pretty good . And it gets better from here out.

vape on!