The new 60w mod says they i need to resolder 16ga wires to the board. Is this really necessary if i dont go over the 30A draw? i dont sub-ohm or anything.
SX350 16 gauge wire
- Thread starter mberlinger3
- Start date
- th_trl_thread_readers 0
- Status
Then dont worry about it. You can dl the 50w rotate display file from the yihi site. Has the current features with out the extra 10w.
Do you think they will keep both sections updated if there are any new fixes or just the 60w one from now on?
I just wanted to say that I am VERY ...... off that they have this "Resistance Too High" error (when 1.0ohm or higher) now with the 60 watt update. What is the point of having the higher wattage when you can't use it with the advertised 9.5V output?
If this ...... you off you can flash down to the 50 watt files, just flash like normal with the files I posted them here: https://drive.google.com/folderview?id=0B0409gtRjPXIQTZOVWlVS3ZZbG8&usp=sharing I also included the logo changer that I included online.
In addition to this I need everyone that this affected to start emailing their customer support. This is completely out of line and they are limiting this chip. Ill get off my soap box now.
If this ...... you off you can flash down to the 50 watt files, just flash like normal with the files I posted them here: https://drive.google.com/folderview?id=0B0409gtRjPXIQTZOVWlVS3ZZbG8&usp=sharing I also included the logo changer that I included online.
In addition to this I need everyone that this affected to start emailing their customer support. This is completely out of line and they are limiting this chip. Ill get off my soap box now.
I run 1.9 ohm coils and if I tried to run that much power it would blow my coil. I know this because I have put it in my pocket with out locking and the power went all the way up. Oh yeah soap box... never mind just ignore my comments. ..
- Status
Similar threads
