Just completed my first dual 18650 SX350 Build, with an external 1 amp micro USB charging board. The existing USB board is reserved for firmware upgrade only (hidden in the box) as to extend the life spam of this device.
I found the dual 18650 is really the way to go. With two brand new EH wrapped SONY VCT4 batteries, the voltage drop became negligible. Single 18650 is just not enough to drive the chip, especially with the negative lead moved to the reverse polarity protection soldering point.
My first SX350 (named Franken MOD was in the fourth picture for size comparison)
I have included a few pictures. Happy vaping !!
I found the dual 18650 is really the way to go. With two brand new EH wrapped SONY VCT4 batteries, the voltage drop became negligible. Single 18650 is just not enough to drive the chip, especially with the negative lead moved to the reverse polarity protection soldering point.
My first SX350 (named Franken MOD was in the fourth picture for size comparison)
I have included a few pictures. Happy vaping !!