tank mod

[bsdmoose]

My 3.7 mil tank mod is hard to drag.Like its stopped up.Geting no vapor.Any ideas

 

[carlton]

Put a new carto in.

 

[ToweKnee]

What mix juice you using? is this a new tank and carto? Did you punch the hole yourself or was it pre punched? need more info really.

 

[bsdmoose]

yes its new

 

[UncleHelmet]

What mix juice you using? is this a new tank and carto? Did you punch the hole yourself or was it pre punched? need more info really.

ToweKnee is dead on with this, there could be several problems. VG juices are more viscous (thicker) than PG juices, this will cause wicking problems with certain carto's due to the holes being a little too small for the VG juice to properly wick the carto. If you did the holes yourself did you punch them or cut them? Punching is the way to go IMO. If its pre-punched what brand is it? More info please.

 

[bsdmoose]

I bought it it has the holes allready my juice is 50-50

 

[SteelJan]

Might be the eliquid's too thick but also does your tank screw down all the way onto your mod? Sometimes I'll have to use an adaptor on some mods where the tank screws down totally flat onto the drip-catch cup, not allowing any airflow.

 

[Adcgn45]

its not the tank its the cart. try a new one or check it for blockages