I just got a few of them I ordered in a co-op and am curious, with the mouthpiece it seems to be hollowed out at the bottom. Should I place cotton in here, or is it made for cartridges? Any advice on how to use these?
TBC-1 Rebuildable Question
- Thread starter Theken
- Start date
- th_trl_thread_readers 0
- Status
They use tank carts. They didn't come with them wrapped seperately? I just recieved 2 from a vendor in china and they came with "blanks" in the atty's and 2 extra carts.
I just got one from the classies. Mine came just the atty and a tank cartridge attached to hold the juice and act as mouthpiece. I havent used it yet, just researching now and linked to this thread. Gonna read up more on it and try using it. Ego type-A maybe for the cartridge size? I'm not sure, but I know its too small to be the type-B.
Just a heads up for the Tbc1 owners. I have a tbc1 and 2. I liked the tbc2 much more than the one with the tank. Soo i just removed the spike plate and use it with ss mesh and 32 Kanthal wire at 4 to six wraps. It is better than the tbc2 now since it holds more juice.
That's an awesome setup!! But, do you still feed the juice using the tank cartridge they come with? If so, how since you removed the spiked plate. I have one at home, and want to do this later tonight!
I feed it by just droping the juice in the section that screws on the first part that goes around the mesh and coil. I don't use the cartridge and cut the drip tip in half so its easier to remove and insert it. Oh and i allso drilled straight through the mouthpece from top to bootom.
- Status
Similar threads
- Locked
