I have an MFeng UX that have temp control built into it and I have a crown iv tank that has stainless steel coils with it out of the box. I tried the tank on an IStixking 530 mod with coil set to stainless, I tried a tcr of 0.000093(I think?) And kept the temp below 400. The Sticking said no juice detected, I looked it up, some people were able to use nickel and it work good. The coil died fast, and I wanna learn how to use temp control without ruining the other coil. Basically, I wanna use it on my mfeng, and not guess at what settings lol. Any advice?
- Status
Crown IV tank utilizes ss904L coils.The CDR is 0.000734
With the higher tcr you setted you burned the cotton.
With the higher tcr you setted you burned the cotton.
Last edited:
Sweet alright, I'll try that out when I get home. Just select stainless steel as coil, and that as a manual tcr?
No.First set the tcr at M1 or M2 or M3. To do that consult the manual.Ussually you gain access by turning off the device,and then holding pressed the fire and the down button simultaneously for 5 sec.
Then select "temperature M1 or M2 or M3" mode (the one with the correct cdr).
Watch the following video,it has a tutorial how to set tcr at M1/M2/M3/M4/M5(basically you need only M1).It has 4 digits so set 0734
MFeng UX - Bing video
MFeng UX - Bing video
After viewing the video and using the tcr preset in M1, and the value you gave me, the juice tastes pretty good. I'm spoiled with mesh coils and just watts but compared to that vsticking mod this is much simpler. Thank you for the help
- Status
Similar threads
