Terminator C V2 ground leg wire question

[dezyner]

Anybody know a tip for Terminator C V2 ground wire trapping on the retainer ring? the thread action is sometimes cutting the soft, no resistance silver leg breaking the ground when trapping behind the retainer. When you leave it exposed and pinch it between the ring and body, it tends to flood it because of the gap created by the wire thickness. I was thinking of not trimming the twisted pair wires together, no res and res, making the leg substantially larger to include both wires? I'm using the twist method to join the res and no res. thanks in advance.

 

[Vego]

Take the neg nr wire and wrap it bunched up a little around the channel wick. When screwing in the base, note a slight resistance as it screws over the nr wire arond the wick. Make it bunched up enough so that it maintains good contact with the housing, but not so much that you can't screw thr housing over it. Good luck.

 

[dezyner]

Take the neg nr wire and wrap it bunched up a little around the channel wick. When screwing in the base, note a slight resistance as it screws over the nr wire arond the wick. Make it bunched up enough so that it maintains good contact with the housing, but not so much that you can't screw thr housing over it. Good luck.

thanks. will do.