Tesla APV Mod and Kanger Subtank Nano compatibility

[graywoulf]

I bought a Tesla APV VV/VW Mod and I I want to get the best flavor experience that I can so somebody recently recommended that I buy one of the new Kanger Subtank Nano tanks to achieve my goal. The Tesla is only rated at 15 watts maximum and I am using EFEST IMR 18650 high drain batteries in it but I am seeing conflicting information about the compatibility of the two devices. I know that the Nano has a 0,5 Ohm coil but also has the option of a 1.2 Ohm coil. I already have a couple of small vaporizer tanks that are rated as low as 1.7 Ohms. I know that the Tesla says that the lowest Ohm coil that will work is a 1.5 but the dealer that wants to sell me the Nano thinks it will work just fine. I need to prevail upon a much more experienced Vaper out there to set me straight on this an or suggest to me an alternative for the Subtank Nano. Thanks for reading this and for an opinions and advice received.

 

[thefleck]

It should work at 1.2 ohms but not lower. There is a little bit of variability with the kanger coils so if you happen to get one that is 1.1 ohms you might be out of luck. I think it will probably work, but it's a bit of a gamble.

In my opinion the kanger works best around 20-30 watts, but i'm not sure if there's a better option out there for 15W, either. You could always get the kanger mini, which has an RBA, and then you could build your own coils >1.2 ohms if the pre-built ones aren't firing. That might be your best bet.