The iHybrid APV - A fully Customizable Genesis

Status
Not open for further replies.

Escapereality

Super Member
ECF Veteran
Verified Member
Jul 25, 2012
407
571
Bluegrass
It takes me a lot longer to get a good coil on my ZAP in comparison to the iHybrid. I have absolutely no idea why that is, it seems when I wrap a coil on the iHybrid all it takes is a couple wiggles and it's good to go. Maybe it's just me and I suck with my ZAP:D

Seems I really just need an insulator for my ZAP (from an old carto). Not quite sure why I don't need one for my iHybrid. Some sort of voodoo magic Faceless puts on these devices...
 

Eric Smith

Super Member
ECF Veteran
Verified Member
pop pop pop goes my coils :(

325 ss mesh, 32g kanthol a1 rolled kinda thin 4/5 wrap vaping for 2 weeks
hope this helps
if i roll it thicker where it barely fits the hole i pop a few inches of wire, i may switch to 28g but no need as of yet

2012-11-26_15-43-49_910.jpg
 

vabeach454

Super Member
ECF Veteran
Verified Member
Jul 28, 2012
899
1,178
Virginia Beach
virginiavapers.com
I'll have an ihybrid hopefully within the week. I've noticed on my ac9 it works well with large hollow wick or a large wick with only a needle size hole running down the center. What works best for you guys on the ihybrid? Personally I use almost all vg juice.

Sent from my SPH-L710 using Tapatalk 2

Your wick settups sound good and should be fine. I use 70/30 PG/VG and I use Fat wicks and a Twisted 32 kanthal with a 4/5 wrap... :)
 

Eric Smith

Super Member
ECF Veteran
Verified Member
Lately I'm really liking gandalf from HHV. But I like it in 100 percent VG. I'm not sure how straight VG works in these ihys. Will it be okay with 400 ss mesh or should I get a 80/20 mix just to be safe ?

Sent from my personalized G-Nex!!!

325 is better, 400 seems to make me tilt more often to get a good toot
 

Escapereality

Super Member
ECF Veteran
Verified Member
Jul 25, 2012
407
571
Bluegrass
I'll have an ihybrid hopefully within the week. I've noticed on my ac9 it works well with large hollow wick or a large wick with only a needle size hole running down the center. What works best for you guys on the ihybrid? Personally I use almost all vg juice.

Sent from my SPH-L710 using Tapatalk 2

I use 400 mesh, with a wick that fits in the hole with quite a bit of wiggle room. Not sure of the exact dimensions. I use twisted 32 awg kanthal with a 3/4 wrap, usually comes out to about 1.1-1.2 ohms.

5yg8s4.jpg
 
Last edited:

Cyclin

Vaping Master
ECF Veteran
Nov 1, 2011
6,761
20,514
California
Twisted Kanthal is considered by some to be cheating when it comes to coil shorts (I don't think so and prefer twisted half the time)

Just make sure to twist you wire tight if you do. Twisted setups don't short as bad or often but you will have to do more wraps or a fatter wick with this, as twisted two strands of kanthal halves the resistance :)
 

Thorbear

Senior Member
ECF Veteran
Verified Member
just thought i'd post this but...rtdvapor has fantastic prices on quantity of wire. most commercial stores sell 2-3 feet for $3 dollars, i just ordered 50 feet of 28ga kanthal for $10

edit: WICK & WIRE

I bought from this supplier on ebay, great prices.

kingorchid | eBay
 

TMC81614

Unregistered Supplier
ECF Veteran
Jul 3, 2011
77
101
51
Raleigh, NC. USA
www.vapingwatch.com
omg... I cant believe what i just got off the classies. I have to sell my paps set now. Faceless i really need some ihy attys. :)

what did you get? Omg that was s score at that price. Jeez


wth is it!!!!!

NM......I see.....and I'm jealous as HEII! That is one fantastic snag!
 

CHARGER72

Super Member
ECF Veteran
Verified Member
Jul 25, 2012
993
1,238
BLOOMINGTON, IL
I think the bulli that was in my avatar that is now in my new avatar is going up in the classies. It is a little to deep of a red my likings. If any one is interested send me a pm. I think it will be perfect on the hellraiser. I just went back to the twisted 32 and wow. Release thr kraken!
 
Status
Not open for further replies.

Users who are viewing this thread