The iHybrid APV - A fully Customizable Genesis

Status
Not open for further replies.

goldcoastmat

Super Member
ECF Veteran
Verified Member
Oct 24, 2012
541
2,139
florida USA
I've also been trying to figure out a way to make it work with the wire INSIDE the wick... I've thought of poking holes with a pin and kind of "sewing" it back and forth but I don't think it'll wick if I did that. using one hole and running it up the center and out the top would be way to low ohms. I'll keep thinking on it but for some reason I really want to try this.
 

Nurzrachit

Ultra Member
ECF Veteran
Verified Member
Sep 14, 2011
1,358
4,684
Gray,GA.
I am assuming they called me and made the appointment...I thought it was too soon...but I guess not..

No they should have most if not all the results for you. I don't know what they are looking for, but some results are only done in certain labs, so it may be send outs. Well just remember Knowledge is power, and if you are having continuous issues, getting to the bottom of things is half the battle. My heart goes out to you though, it is easy for me to say don't worry, but a much harder thing to do if it is your test results.
Before I quit smoking I had an annual chest x-ray with my physical March 2011. For some reason that was never properly explained to me the x-ray was misplaced and I never heard anything about it so I assumed it was Normal. One year later my Doctors office called me on a Friday afternoon a couple weeks before my annual physical and stated they needed to see me Monday morning to have labs and a follow up x-ray. They then proceeded to tell me my x-ray from the previous year showed a pleural effusion in my right lower lobe with blunting. I had to digest that over the weekend, and by Monday morning I had my choice of hospices picked out, and was debating burial or creamation. Thankfully my follow up x-ray was negative, thanks e-cigs! But it just goes to show you the power of the mind, and what can happen if you focus on one thing too long. Sometimes it sucks being medically inclined, you always imagine the worst case scenario's. Sore Throat=Esophageal Cancer, when in reality it is just a sore throat:D. I will say a prayer for you, and no matter what, you got your wonderful families for support!
 

Nurzrachit

Ultra Member
ECF Veteran
Verified Member
Sep 14, 2011
1,358
4,684
Gray,GA.
Scubagenmini v3. It's a genesis atty, designed by Scubabatdan, and Rusalka is running the co-op for it. HUGE machinist problems. Thread opened way before this one. No one has gotten a device yet. Money has been collected. Machinist has gotten partial payment, and is extremely uncommunicative. Tough situation.

Sent from my Galaxy Nexus using Tapatalk 2

yikes, what a nightmare.
 

amienichole

Moved On
Aug 16, 2012
1,506
16,160
54
Tennessee
No they should have most if not all the results for you. I don't know what they are looking for, but some results are only done in certain labs, so it may be send outs. Well just remember Knowledge is power, and if you are having continuous issues, getting to the bottom of things is half the battle. My heart goes out to you though, it is easy for me to say don't worry, but a much harder thing to do if it is your test results.
Before I quit smoking I had an annual chest x-ray with my physical March 2011. For some reason that was never properly explained to me the x-ray was misplaced and I never heard anything about it so I assumed it was Normal. One year later my Doctors office called me on a Friday afternoon a couple weeks before my annual physical and stated they needed to see me Monday morning to have labs and a follow up x-ray. They then proceeded to tell me my x-ray from the previous year showed a pleural effusion in my right lower lobe with blunting. I had to digest that over the weekend, and by Monday morning I had my choice of hospices picked out, and was debating burial or creamation. Thankfully my follow up x-ray was negative, thanks e-cigs! But it just goes to show you the power of the mind, and what can happen if you focus on one thing too long. Sometimes it sucks being medically inclined, you always imagine the worst case scenario's. Sore Throat=Esophageal Cancer, when in reality it is just a sore throat:D. I will say a prayer for you, and no matter what, you got your wonderful families for support!

Thank you so much:). I sent cha a pm:)
 

Nurzrachit

Ultra Member
ECF Veteran
Verified Member
Sep 14, 2011
1,358
4,684
Gray,GA.
Kind of like a SS mesh Cartomizer? You would have to roll a hollow wick with the inside oxidized, probably jack frost the shiit out of it prior to rolling a hollow wick. Make an extremely tight coil, possible peter k it around a 1mm drill bit, and slip it down the middle. connecting to pos and neg posts would pose a problem though, because you would have to figure a way to get the coil ends through the mesh wall to make your connections close enough to avoid hot spots. Holy Mackrel, that sounds like alot of work!
 

pnc81498

Vaping Master
ECF Veteran
Verified Member
Sep 20, 2011
4,630
14,798
54
Central NJ
i have a 1978 kz 1000 stripped down to the frame with all the part it was my first bike..i have had it for 26 years.

Had A 750 nice thing was 1k parts bolted up so easy, I miss that bike but with open pipes I know everyone else don't. rode it from NJ to Virginia it was so long I slept on it. Ahh I miss being young.


From my phone
 

amienichole

Moved On
Aug 16, 2012
1,506
16,160
54
Tennessee
Here is our creek over flowing and now they are calling for snow tonight and tomorrow
image.jpg
 

Nurzrachit

Ultra Member
ECF Veteran
Verified Member
Sep 14, 2011
1,358
4,684
Gray,GA.
Here is our creek over flowing and now they are calling for snow tonight and tomorrow
View attachment 169508

That looks like a blast on the 4 wheelers. We have a creek at the base of my yard, and we ride in it in the summer. When it overflows/floods though it is kind of scary. My house is well above it, but water is so destructive and powerful. On second thought the 4 wheeler idea=not so good!
 

silentdoom

Ultra Member
ECF Veteran
Verified Member
Feb 2, 2010
1,602
1,896
MO
Ohhh they just showed the new Corvette StingRay...beautiful:)

Saw that the other day. iThink I like it? :) gotta see it in person!

So I think I know why we were having trouble finding out what brass was in those "other" tru-stone tips. With some blanks of that material, you can get it predrilled for making pens and it comes with that brass tube installed. So what I'm thinking is he/she probably has no idea what kind of brass it is... I wouldn't think it's any high-grade brass, so someone could have the potential of getting hurt. I don't have the right to hurt any of his business, but WE do have the right to know.

Personally, this makes me glad that I'm using bully tips, which use SS in the center hole. When I was collecting guitars, my grandpa always told me: quality over quantity. Hope this helps everyone.
 

Nurzrachit

Ultra Member
ECF Veteran
Verified Member
Sep 14, 2011
1,358
4,684
Gray,GA.
Had A 750 nice thing was 1k parts bolted up so easy, I miss that bike but with open pipes I know everyone else don't. rode it from NJ to Virginia it was so long I slept on it. Ahh I miss being young.


From my phone

That is one of my favorite sounds. 4 into 1 header on a kz750/900/1000 is sweet music!!!!

 

goldcoastmat

Super Member
ECF Veteran
Verified Member
Oct 24, 2012
541
2,139
florida USA
Im having trouble with the infamous top coil hot spot.
Ive been at it for a hour.

Careful

Fire + beard = bad

edit: yes I know a top hotspot isnt likely to set your beard on fire, really I just wanted the mental picture of you running outside with a flaming beard to dunk your head in a rainbarrel to put it out.

mission accomplished.
 
Last edited:

Sgresham

Super Member
ECF Veteran
Verified Member
Nov 12, 2012
550
1,339
49
Texas
Saw that the other day. iThink I like it? :) gotta see it in person!

So I think I know why we were having trouble finding out what brass was in those "other" tru-stone tips. With some blanks of that material, you can get it predrilled for making pens and it comes with that brass tube installed. So what I'm thinking is he/she probably has no idea what kind of brass it is... I wouldn't think it's any high-grade brass, so someone could have the potential of getting hurt. I don't have the right to hurt any of his business, but WE do have the right to know.

Personally, this makes me glad that I'm using bully tips, which use SS in the center hole. When I was collecting guitars, my grandpa always told me: quality over quantity. Hope this helps everyone.

That is probably exactly what the issue is. I saw this guy's work on etsy, and his pens and razors are really nice. I actually was going to get one of his Mach 3s, but not if he won't answer a very critical question. That is not a good business practice at all.
 

Nurzrachit

Ultra Member
ECF Veteran
Verified Member
Sep 14, 2011
1,358
4,684
Gray,GA.
28 guage 3 wrap, my go to coil

Yea that's a good un. I'm a little surprised though, they don't usually happen with that guage. may have to do a little low batt vaping till it gets some break-in. or just tear the sucker off and have another go. good luck man.
 
Status
Not open for further replies.

Users who are viewing this thread