The iHybrid APV - A fully Customizable Genesis

Status
Not open for further replies.

Shaitaan

Vaping Master
ECF Veteran
Verified Member
Jul 8, 2011
4,607
5,063
Syracuse, NY
yea IF I miss on the red dragons, I'll have to wait until another kewl black or red one comes out...wishing I had started looking sooner, I may not have missed out on the black widow version... no worries, I will have a 2nd sooner or later ;) the one I started rolling, will be evilly goodness, of course...

:evil::evil::evil:

Oooo super secret designs I don't know about!

That's gona drive me nuts.

Can only get 1 more and I'm gonna miss out on some cool ones waiting for cooler ones to come out lololol
 

Fisty

Ultra Member
ECF Veteran
May 13, 2012
2,811
6,475
Rochester, NY, USA

MaxPerilous

Ultra Member
ECF Veteran
Verified Member
Sep 12, 2012
1,574
1,379
39
Edgewood, NM
One thing I will tell you Shai.....good luck keeping up with both threads! Too many good people in both not to, so like me, you will, but it's a full time job!!!

Thats for damn sure! I go to sleep then I have to read to catch up for just as many hours lol
 

DarklyNoon

Ultra Member
ECF Veteran
Verified Member
Aug 1, 2012
1,002
1,370
46
Virginia
So I'm researching rolling wicks for future endeavors and it seems there are two schools of thought, tightly rolled, and straw type wicks. I'd like to keep em as close to 3mm outside diameter as possible as I'd like to fill the entire wick hole. According to the tomcatt pv calculator app, a tightly rolled 3mm wick would be 141mm (5.55") of mesh material. This seems excessive to me, so perhaps a loosely rolled, straw type wick would work better for wicking and flavor... Then there's the dual wick method. I'm looking specifically for advice from anyone who uses a 3mm wick, and can give measurements on lengths of material to use. Any thoughts from the Genesis/iHybrid veterans?
 

MaxPerilous

Ultra Member
ECF Veteran
Verified Member
Sep 12, 2012
1,574
1,379
39
Edgewood, NM
2012-10-23 01.57.59.jpg

For some reason I cant post a pic in PM? But I can here....
 
Status
Not open for further replies.

Users who are viewing this thread