Status
Not open for further replies.

Jackass69

Super Member
ECF Veteran
Verified Member
Apr 20, 2011
554
250
Sweden
Check the hardware store in the plumbing repair section for the bottle o-ring.

Best I can measure: 19/64" ID x 3/64" Thick

Gve or take 1/64". It's not critical to be exact

Thanks. I found one in right size among the "many things that is going to be of use one day" stash :)
The bottle is firm and well in place now.
 

AlmightyGod

My friends call me A.G.
ECF Veteran
Verified Member
Nov 23, 2010
10,685
9,506
Vaping Heaven
I'm enjoying discovering my new Vmod. I really like the clean taste it gives to the juice. I'm using it with the 1.8 ohm silo and enjoying the experience but I just wish the draw with a bit tighter. Either a tighter draw or a hotter vapor....right now I experience nothing on the inhale, only on the exhale

Try a direct lung inhale with the Vmod...it's good!
 

Scotay87

Super Member
ECF Veteran
Jul 20, 2011
508
285
Pacific North West
He there Vmod gang.... After 4 days of high mountain camping and no service than almost a whole day of no ECF service I am in serious with-drawls.... Now that I am back and ECF is back I thought I would shout out a big HELLO... I would also like to let ya'll know that no leeky for the whole time with the new chassis and new v1.1 Vmod... 4 days of rattling in my pockets with other junk besides a few scratches only problem was a build up of clean mt dirt.... Here is a pic of where I was...
photo3-1.jpg


The pic was taken at about 6'000' elevation after an hour or so hike from the lake below at 4'500'
 
Status
Not open for further replies.

Users who are viewing this thread