This is going to be a dumb question but...

[the ob]

Will you tell me if it is normal for this much juice to sit below the adjustment ring and the channels where the juice is fed through my ody

As you can see about half the juice sits below the channels where it gets fed up. I then have to tip it.

I have a strong feeling I have something put together wrong.

This is in small mode I think.

Thanks!

 

[foutouristas]

your setup is fine ob, mine with clear windows looks exactly the same.. you 're also right about the tipping, it's a thing you have with the clears...

 

[keighles]

yep, that's normal

 

[the ob]

so do the metals fit differently? I mean are they narrower?

I am not complaining mind you, I just thought I was doing something wrong. I am still figuring all this stuff out.

 

[foutouristas]

the metal body is thinner, and this explains the difference when you put the clear windows on.. it has to do with the nature of the materials, polycarbonate tubes cannot be cut this thin, cause they'd break..

as for the gaps inside, I think there is little difference between the clear and the SS body, liquid still reaches the wick due to pressure and laws of fluid mechanics.. it does become harder and harder though, when it reaches its crusial minimum level

 

[unloaded]

The main difference between the metal and poly tank....you can see whats happening in the poly one.

 

[the ob]

thanks everyone! Much appreciated. I thought I was losing my mind. not that I am not still in danger of that.

 

[unloaded]

You should post that second pic in this thread:
http://www.e-cigarette-forum.com/forum/provari/273949-lets-see-your-tanks-holy-grail.html

 

[Bubbertyboo]

I can vape mine dry the juice always finds its way to the wick.

sent using carrier pigeon.

 

[The Yeti]

With the GGTS Ody base, that bottom nut sits flush.