Tobh vs Omega

[BDR91]

Ok so what one is better for clouds. Now I know that it's mostly the build in them, I can build a coil no problem. Witch one performs better for clouds that is what I'm wondering.
Any input would be appreciated and builds that work best in them. Thanks

Sent from my HTCONE using Tapatalk

 

[crxess]

Only advantage I'd claim in one over the other is the juice well depth of the Tobh.

I run an Omega quad coiled and it is great, even at .67ohm but easy to over fill and 3mm holes like loose e-liquid.

 

[BDR91]

I never usually run anything higher than a .5 maybe a .6

Sent from my HTCONE using Tapatalk

 

[Joka]

Ok my personal opinion on this subject because i have them both. Is get them both =D roughly $30 for the omega v2 and $20 for the tobh v2. They do vape completely different. However the tobh leaves more room for air flow holes to be added. You could add them to the omega if you wanted, but it would be difficult to add them low because of the deck. The omega may have a "slight" bit more open air flow. Neither has too little for stock. I will go on to say DO NOT buy the cheap ... $6 clone of the omega. Get the ehpro v2 clone. Its WAY better quality and has the air flow holes lined up in a better spot, with big flat top screws, holes in the post, and a better quality cap and bette4 engraved omega symbol. I will post pictures side by side for beauty and maybe that could help a little.

 

[suspectK]

Omega has better stock airflow and flavor..I think it looks better, and if you put a tobh in a pocket, get out a lent duster for the heat sink..

You could open up a tobh easier for more vapor production, but I was surprised to find out they have practically the same capacity..

 

[BDR91]

I just bought both tonight

Sent from my HTCONE using Tapatalk

 

[Joka]

Heck yew bro, build em up and lets see them beauties

Sent from my SCH-I545 using Tapatalk

 

[BDR91]

Here they are both have .5 ohm builds they both kick some ...


Sent from my HTCONE using Tapatalk

 

[suspectK]

I just flipped my chamber on my hcigar tobh. I didn't make a new build...I popped so many legs with dual-wire coils with 28awg, yesterday.. I'll do one special for it tomorrow. The body will need to have a recess put in it to sit flush. I need to ask a friend to tell me what would be the best approach for that, but actual capacity.. I honestly don't get any difference in capacity between omega or tobh. Not to mention, I was getting wobble from the heat sink.. Since it's sitting in the recess, it's not wobbling, and heat sink is functioning, unlike before.

 

[suspectK]

K..got bored.. just went with 26awg.

First go at heat treatment... need a better torch, on 4nine..I kinda like the gap from the cap being upside down, accents copper top cap.