Hardware
Darkhorse clone by infinite
Copper penny mod clone by hcigar
Purple efest 18650 2500mah 35 amp batteries
Organic cotton balls
24gauge kanthal A1
90vg 10pg juice
So I've been trying to find out what's the best setup for me. Here is what I have tried
dual macro coils wrapped on a 1/8th inch drill bit, .2 ohms, .35 ohms, .5 ohms The lower the ohm the warmer the vape. I do like this build at .2 or .25 but I am not happy with the vapor production. I think I should be able to get more vapor but the flavor is good
dual micro coils wrapped on the little blue screwdriver that came with the rda .3 ohms right now, very cool vape decent vapor production. Not warm enough and would like more vapor the flavor is good
single parallel coil, too warm of a vape, feels like its gonna burn my lips at .25 ohm in single coil mode, good vapor production great flavor just too hot
All these build were done with 24g kanthal and the blue screwdriver or 1/8th inch drill bit like I described. I am looking to get more vapor production.
Any ideas on what I should try? I only have 24g kanthal 90ft of it, I'm open to all ideas
Thanks in advance everyone
Darkhorse clone by infinite
Copper penny mod clone by hcigar
Purple efest 18650 2500mah 35 amp batteries
Organic cotton balls
24gauge kanthal A1
90vg 10pg juice
So I've been trying to find out what's the best setup for me. Here is what I have tried
dual macro coils wrapped on a 1/8th inch drill bit, .2 ohms, .35 ohms, .5 ohms The lower the ohm the warmer the vape. I do like this build at .2 or .25 but I am not happy with the vapor production. I think I should be able to get more vapor but the flavor is good
dual micro coils wrapped on the little blue screwdriver that came with the rda .3 ohms right now, very cool vape decent vapor production. Not warm enough and would like more vapor the flavor is good
single parallel coil, too warm of a vape, feels like its gonna burn my lips at .25 ohm in single coil mode, good vapor production great flavor just too hot
All these build were done with 24g kanthal and the blue screwdriver or 1/8th inch drill bit like I described. I am looking to get more vapor production.
Any ideas on what I should try? I only have 24g kanthal 90ft of it, I'm open to all ideas
Thanks in advance everyone
