two bad cartos... two attempts to load ultrapure

[7spokenightmare]

The stuff I seem to use most is all vg (ultrapure from innovapor) with zero pg in it. Works great in all my atomizers. I recently ran out and got some pg/vg mixed stuff to hold me over (never got a straight answer on the ratio). During this time I picked up some boge cartos and the interim stuff vaped fine in them... Now I got my regular stuff back and I loaded two of my new cartos (that I hadnt used yet) with my all vg goodness. Niether cartos will wick at all... I can look in them while firing my battery and I just see an orange glow (the coil burning) and all I taste is burning coil too.... Bad cartos? Or is there an issue wicking this stuff in a carto?? I've read darker juices can kill a cartos, but I can't get even one clean puff out of them and my juice is clear as water



Oh and just as an aside, the stuff that did work was a a pretty dark brown... Go figure :/

 

[meMYSELFnI]

It has to do with the viscosity of your liquid. I've found that a 50/50 or close to that mix works really well in boge cartos.
100% by is fine for dripping but wont work very well in cartos that need to wick.
Depending on the liquid, some liquids wick even better at a higher PG ratio. 60-70 PG to 30-40 VG.
just my. 02

 

[salemgold]

I have read numerous posts around the forum about there being bad batches of Boge cartos out there.
I use a 50/50 blend with dual coils and never have had a problem. I used to use Boges with the same 50/50 blend with no issues at all.

Even with heavier VG liquids, if the cartos are left to sit for awhile after filling they should eventually wick.

Good luck.