Thought i would share what i did last night with my modded ST Vivi tank(drilled wick hole/air-hole in tube/bottom air-holes plugged).
All Mesh is T316 grade SS. The U-Shaped wick is 325, has no creases and was oxidized when already in U shape so it kept the U nicely. 1 leg is 325 Mesh while other is 400. Wicks like a beast! Reason i did this so no matter which juice it has(thinner(100% PG) or thicker(100% VG) or anywhere in between) at least one leg is working properly. I know some say both 325 and 400 wick the same - but i noticed a difference - to each its own. Trying to go into all SS(no silica/FB/Cotton - unless hybrid with coil-on-mesh) so trying new things
All Mesh is T316 grade SS. The U-Shaped wick is 325, has no creases and was oxidized when already in U shape so it kept the U nicely. 1 leg is 325 Mesh while other is 400. Wicks like a beast! Reason i did this so no matter which juice it has(thinner(100% PG) or thicker(100% VG) or anywhere in between) at least one leg is working properly. I know some say both 325 and 400 wick the same - but i noticed a difference - to each its own. Trying to go into all SS(no silica/FB/Cotton - unless hybrid with coil-on-mesh) so trying new things