UFS question

Status
Not open for further replies.

Aal_

Vaping Master
ECF Veteran
Verified Member
May 5, 2012
7,077
18,611
Toronto
I am using my UFS with a 510 atomizer the one where the coil is showing and around it some kind of steel stuff. Anyway, no problem with the UFS until I put it down for like 5 mins vertical position. Then when I pick it up. It is dry. Painful dry! When I put it for the 5 mins the juice control is half a turn open and the air control is quarter turn open. What might be happening? Is the liquid going back to the tank. Is this scientifically possible since there should be air inside the tank (or is it vacum)? Or is it going through the center post into the collector tank? It is not a big deal since 3 drags without button solves it but it is annoying when you forget and get that scratchy throat that makes you cry sometimes :(
 

Bishopheals

Reviewer / Blogger
ECF Veteran
Verified Member
May 23, 2012
2,266
1,772
50
Staten Island
www.youtube.com
here's the way i use it. When using drip atty I leave juice control two turns open. Air control is a quarter open. I take 2 hard drags without firing then I proceed to fire the device and take 3-6 decent pulls. MMmmm AAAAAAAA

I keep doing that till I need more juice then I take 2 hard pulls with out firing the button and rinse and repeat. When I am done using ufs I only close juice control leaving air control open. I can leave device standing up or laying down no leak.

When using it again i apply same steps as I mentioned above.
 

Aal_

Vaping Master
ECF Veteran
Verified Member
May 5, 2012
7,077
18,611
Toronto
here's the way i use it. When using drip atty I leave juice control two turns open. Air control is a quarter open. I take 2 hard drags without firing then I proceed to fire the device and take 3-6 decent pulls. MMmmm AAAAAAAA

I keep doing that till I need more juice then I take 2 hard pulls with out firing the button and rinse and repeat. When I am done using ufs I only close juice control leaving air control open. I can leave device standing up or laying down no leak.

When using it again i apply same steps as I mentioned above.

Bish I am not having any leaks. I'm just wondering why it would dry up when not in use.
 
Status
Not open for further replies.

Users who are viewing this thread