Under the bridge of the atomizer question

[icemanx3]

Hi!

Today I blew out my 510 atomizer and from beneath the bridge some amount of white thread material came out. It's possible that this white thread material helps wick juice from the mesh of the bridge down to the hot filament. I think this stuff is necessary because now my atomizer filament gets red hot, but I get zero vapor.

Any tips on what that stuff is, and how I can replace it?

Thank you!

ice

 

[icemanx3]

Oh great...I think I found out what it was. It's the "wick" that runs through the coil "hot filament" and it does touch the mesh and helps draw the juice from the mesh to the coil

That seems like it would be REALLY hard to replace...even with the how to...does anyone have any other suggestions?

http://www.e-cigarette-forum.com/fo...your-510-atomizer-step-step-801-901s-too.html

Thanks!

ice

 

[Chalie_Champ]

well, best and fastest and easyest way would be to order another atty, but if it is the wick, you dont need it to vape, you an use the atty for driping and it works better then dripping with the wick in it.

 

[icemanx3]

Thanks for your feedback! BTW, I just found the thread of how to remove the mesh and the bridge for direct dripping to the coil. I tried it and removed the bridge and the freaking thing works AMAZING!!!

ice

 

[Chalie_Champ]

yea its ok, not even close to a 306LR by the way what PV do you use, if it has a battery of 650mah or higher then deff you need a LR306

 

[icemanx3]

I'm using a 1200mAh batt in my yummy RoughStack mod...