Ya it doesn't get hot at all. Ty again midniteoyl!!
Sent from my Galaxy Nexus using Tapatalk
Sent from my Galaxy Nexus using Tapatalk
vamo v5 battery help.
- Thread starter deftonerdad
- Start date
- th_trl_thread_readers 0
- Status
Whatever tastes best for you... 
No, really, most people start out by adding 2v to the coil ohm or 8 watts and adjust from there.. So 1.6 + 2 = 3.6v. That should get you right around 8.1watts... Using either Volts or watts, doesnt matter.
TIP: If the juice always tastes 'burnt', make sure the Vamo is in 'RMS' mode and not 'Mean'. Do this by holding the LEFT adjustment button for 12-13 seconds. If 'Output MEAN' shows up[, hold it again for 12-13 secs until you see 'Output RMS'. You are now in RMS mode.
No, really, most people start out by adding 2v to the coil ohm or 8 watts and adjust from there.. So 1.6 + 2 = 3.6v. That should get you right around 8.1watts... Using either Volts or watts, doesnt matter.
TIP: If the juice always tastes 'burnt', make sure the Vamo is in 'RMS' mode and not 'Mean'. Do this by holding the LEFT adjustment button for 12-13 seconds. If 'Output MEAN' shows up[, hold it again for 12-13 secs until you see 'Output RMS'. You are now in RMS mode.
guys I bought some 1.2 coils for my mini protank 3 it should work on my vamo v5 but it wont , says low ohm... So any ideas ?
Some coils actually read lower than claimed and some VAMO's actually need higher than the 1.2ohm claimed. My VAMO will actually do closer to 1ohm, but I try to stick closer to 1.2-1.4ohm when building. For your case, I would buy 1.5-1.8ohm coils.
- Status
Similar threads
