Vamo V5 Help!! I don't know how to use it properly!

[Feaga2105]

I've just upgraded from a standard kit to a Vamo V5. However i'm not sure how to set the voltage (v) or power (w) output properly. Am i supposed to be setting both the volts and watts in accordance to what i'm vaping or with the ohms based on the tanks i'm using?? Or do i just need to set the voltage??

 

[xtwosm0kesx]

I've just upgraded from a standard kit to a Vamo V5. However i'm not sure how to set the voltage (v) or power (w) output properly. Am i supposed to be setting both the volts and watts in accordance to what i'm vaping or with the ohms based on the tanks i'm using?? Or do i just need to set the voltage??

The vamo is only in one mode at a time, so either in voltage mode or wattage mode.

Your best bet is to set it to wattage mode, and start at about 6.5 watts then move up till you find your sweet spot, or it starts to taste burnt.

If you prefer to use voltage mode, tell us what the resistance of your coil/type of tank is and people should be able to offer advice. Or follow a similar system and start at 3.6v and move up till you find your zone or it tasted burnt.

Best of luck!

 

[Feaga2105]

Hi thanks for your quick response! I'm currently using an Iclear 30b tank which is 2.0 ohms and an Iclear 30 which is 2.2 ohms. I've also got a vivi nova tank 2.7 ohms which tastes burnt all the time so i'm taking this back to my local vaping shop.

So what your saying is as soon as it tastes burnt turn it down and thats the sweet spot???

 

[Katya]

Maybe this will help:



You could also upload a Vamo User's manual.

Or visit our Vamo subforum:

http://www.e-cigarette-forum.com/forum/vamo/

 

[Bunnykiller]

set the vamo to watts mode first... get a feel for the sweet spot ( slightly warm, flavor at peak ) 2ish ohms does well in the 6-9 watt range ( also depends on your juice choice too) once you become comfy with the Vamo, consider trying out the volts setting to fine tune the vape.. if you change toppers alot be sure to keep track of the ohms of each topper in volt mode, keep a note book in the beginning....

 

[dice57]

Yeah, just keep cranking it up till it don't taste good, then turn it down some. Your iclear's will probably be able to handle 10 watts, so don't be shy with turning it up a tad. I pretty much vape all my tanks at the highest watts that my mods can put out, that's my sweet spot.

 

[Bunnykiller]

be careful with going too far on the burnt taste once you notice a bitter taste on the draw, stop there then back it down 1 watt or so...
if you go too far you may toast the wick (YACK)..

 

[rucni]

i am using a vamo v3 with protank 3's 2ohm dual coils and i am anywhere from 3.6-4.0 volts for my favorite juices.

 

[Feaga2105]

Thanks for your advice, i'm going to have a play around with it now. I've just ordered some Zeus Juice from the US as i've read this is a very good vape. Thanks again

 

[shynsly]

Also make sure that it is running in RMS mode. Hold down the left button (-) for about 10 sec. it will show what mode it is in, either "MEAN" or "RMS" you want RMS as MEAN is MEAN.... just sayin..

You will like your vamo i like all of mine.
Good Luck!!!

 

[ZombieJuice]

What he said ^^^^^^ Make sure it is in RMS mode and not mean. Can't believe that wasn't the first suggestion in this thread, I've been getting so frustrated in this forum with some of the advice people are trying to give to new vapers. Not necessarily this thread but there's a lot of posts where people are giving very poor advice to people.

Sent from my Nexus 7 using Tapatalk