Vaping Power Chart

[Ryedan]

View attachment 394088

Just got my orchid... Make 0.7 ohm from 28 awg khantal 9 wrap....
Can't use the Vamo so use mech mod. Work like charm

So 4.2 volt fully charged vct 4, 0.7 ohm... I must be doing around 25 watts right?

It depends on how much internal resistance your battery has and the mod resistance. Your battery at 4.2V will see around 25 watts, 6 amp drain, but your vape power will probably be closer to 21-22 watts.

 

[Ryedan]

Those charts are NOT obsolete. They are a Starting Point.

A starting point if someone is using a low power clearomizer like a CE4 or a Vivi Nova. Completely obsolete with the new higher power clearos, most cartos, or rebuildables. Unfortunately, the charts don't generally don't mention that

 

[Racehorse]

A starting point if someone is using a low power clearomizer like a CE4 or a Vivi Nova. Completely obsolete with the new higher power clearos, most cartos, or rebuildables. Unfortunately, the charts don't generally don't mention that

Unfortunately, vaping charts don't mention newbies who know nothing about battery safety, or ohms law, either----or the ones who don't even own a multimeter. .

It's called SAFE vaping chart for a reason, I think people should still "start there", because just studying the chart a little bit will lead them to at least begin to "see" certain relationships

 

[Phassat]

Unfortunately, vaping charts don't mention newbies who know nothing about battery safety, or ohms law, either----or the ones who don't even own a multimeter. .

It's called SAFE vaping chart for a reason, I think people should still "start there", because just studying the chart a little bit will lead them to at least begin to "see" certain relationships

Lucky for me... As a noob... I've read to use proper batteries only and lower ohm, higher risk... I won't go below 0.7 ohm yet.

I don't have ohm meter... But my vamo v5 does the trick for me. Anyway I always do 9-12 wraps of awg 28 on dual coil... It won't be far from 0.7-0.8 ohm I suppose

 

[Phassat]

Are you guessing?
Ohm's law | Steam Engine | free vaping calculators

Be safe
I

Errr.... Guessing a bit... I just know not to go too low on ohm and always use vct 4 or vct 5.

The 0.7 ohm was my vamo reading. I always plug it in to vamo first and read the ohm

 

[Phassat]

For the ohm.. I use:
http://www.steam-engine.org/coil.asp?s=dp&r=1&awg=28&id=2&ll=6

But that's on preparation only... I was about to make 1.2 ohm dual coil but it will be too many wrap for me...:
The more I wrap the messier it become... So 0.7 ohm should be okay