Vapor Shark rDNA 40 510 issue

[Zombiecan]

So I got my VS rDNA 40 last week and I am having an issue with the 510 connection. Basically what's happening is that when I put one of my rda's either the plumeveil 1.5 or the stillare on it, it wobbles. I have tried tightening down really good and they still wobble around. It does not do this with my kayfun 3.1, kayfun lite plus or the Aspire Atlantis. I have no clue what is going on or why it's doing this. I have not contacted vapor shark yet but just wanted to know if anyone out there has the VS rDNA 40 and is having this same issue or anyone who has a previous VS that can comment or suggest anything. Thank you for your time.

 

[bigrf85]

if it doesnt do it with the kayfun i would lean more towards a irregular threading on the attys rather than the mod beings if it were the mod all devices would do it i would assume

just my thought though

 

[Zombiecan]

if it doesnt do it with the kayfun i would lean more towards a irregular threading on the attys rather than the mod beings if it were the mod all devices would do it i would assume

just my thought though

Well yea that would make sense and all but it does it with both my rda's. I have an omega I don't use I'll try that and see if it does the same thing. But I figured when I tighten the attys down really tight to the point where I have to use something to grip on to it to get it off that it would not wobble side to side so freely. I just hate to think that it'll do this with all future rda's. Granted I have mechs to throw the rda's but I like the performance I get using rda's on the DNA 40

 

[KGB7]

If it wobbles, then the RDA is not flush with the DNA body or the 510 connector. Thus the 510 connector it self is lose.

 

[stevegmu]

Is the pin loose without anything on it? are the RDAs duplicates or originals?

 

[Zombiecan]

If it wobbles, then the RDA is not flush with the DNA body or the 510 connector. Thus the 510 connector it self is lose.

The 510 connection is not lose. The center pin/contact pin moves freely up and down with some resistance due to the sprint or what ever mechanism it uses. I think it may have to do with the 510 post on the rda's being a little bit longer maybe? I do notice now that I have taken a closer look that the other 510 connections seem shorter. Also noticed it does it more on the stillare because I do have to adjust the battery rattle pin on my mechs more out with it as well

 

[Zombiecan]

Is the pin loose without anything on it? are the RDAs duplicates or originals?

All clones or "duplicates" but I think I may have found the issue which is probably due to the 510 connections on my rda's. I guess I'll just stick to using them on my mechs since the VS won't adjust to accommodate them