Vaporshark Question

[mrdfield]

Hello all,
I own a vaporshark and a provari 2.5
I have found after numerous kayfun coil builds that I like 1.3 to 1.4 ohm coil
I vape this on my provari at 3.8 volts but on the vaporshark rdna 30 I can only vape at like 12 watts which gives me 4 volts
Any lower and the ohms start flashing on the dna
What I'm i not understanding
I like being able to vape at 3.8 volts on the rdna like I can on my provari
Please help me understand this
Or is .2 not a big deal




Sent from my iPhone using Tapatalk

 

[bwh79]

DNA30 won't fire lower than 4 volts. It says so in the data sheet. You could build at higher ohms to get less power from that same 4 volts, but that's your only option other than "just deal with it."

 

[Double Helix]

The DNA30 chip in the Vaporshark only supports a minimum use of 4 volts while I believe the Provari supports down to 2.9. You can fire the kayfun below 4 volts on the vaporshark, but it will still be firing at 4 volts regardless. An extra 0.2 volts isn't a problem as long as you're avoiding dry hits. Not much you can do other than sticking with the Provari if that's the setting you really want.