Vaporshark rdna40 reading ohms wrong?

[samstringerhye]

So I just got an rdna40 after using my ipv mini and using kanthal coils it reads on the rdna40 as .67 ohms. On my ohm reader and my ipv mini it reads at .5ohms. It seems to read the nickel coils okay but is this something I should be worried about?


Sent from my iPhone using Tapatalk

 

[K_Tech]

So I just got an rdna40 after using my ipv mini and using kanthal coils it reads on the rdna40 as .67 ohms. On my ohm reader and my ipv mini it reads at .5ohms. It seems to read the nickel coils okay but is this something I should be worried about?


Sent from my iPhone using Tapatalk

I don't have a Vapor Shark, but I have a few Evolv powered devices, and I would trust the VS over an ohm reader, depending on what you're using.

Can you check your device on another mod to get a comparison?

Duh. Sorry about that, totally missed the IPV part.

Does the atomizer have an adjustable 510 pin? Even though the VS has a spring-loaded 510, the 510 pin on the atomizer may not be quite long enough to make a good, solid contact with the VS. I've seen that happen on a couple mods myself.

 

[samstringerhye]

I don't have a Vapor Shark, but I have a few Evolv powered devices, and I would trust the VS over an ohm reader, depending on what you're using.

Can you check your device on another mod to get a comparison?

On my ipvmini it reads at .5


Sent from my iPhone using Tapatalk