Vision stardust won't heat up

[homeprogreen]

Need a little help figuring this one out. My wife has a vision stardust that she uses on a eGo 900mah battery. It was working fine and she went to refill it. After it was filled back up it wouldn't vape. I figured coil head came loose so tightened it down. Still nothing. Grabbed a new 3.2 ohm head from sealed blister pack. Put it on. Still nothing. I'm lost on this one. Any advice will be appreciated

 

[Urge]

Pull the center tube down with a pair of needlenose pliers.

Urge

 

[homeprogreen]

Thanks I will try that

 

[homeprogreen]

Nothing. pulled post down. Tried 1.8 ohm, 2.4ohm and 3.2 ohm heads.

 

[TomCatt]

Check the silicone seals/gaskets, sounds like you have a short somewhere in the Stardust.

 

[homeprogreen]

Thanks. Hate to just toss it since its only 2 weeks old

 

[GGidaho32]

Hey Home, another thing to check is the battery. The center pin might have been pushed too far down and needs to be worked up a little. Use a very small screwdriver and lift up that pin, just lift a little in a few spots around it and then try again. I also noticed that sometimes buildup can be on the silicone, so clean that up good with a qtip. Hope this helps.