Hello all,
I need some advice concerning voltage drop.
I'm currently running an Society Vapors Athena with an kayfun 4, using Kanthal wire 28awg wrapped to a coil with 0.9 Ohm.
The mod is set to 15 watts.
If I put a fully charged battery in the mod it shows naturally 4.2volts on the screen, once I push the fire button the voltage dropps to 3.2volts.
Thats a drop of 1 volt.... I always was under the impression that anything from 0.3 to 0.5 is normal....
Well, how can I improve this?
Thanks
Alex
I need some advice concerning voltage drop.
I'm currently running an Society Vapors Athena with an kayfun 4, using Kanthal wire 28awg wrapped to a coil with 0.9 Ohm.
The mod is set to 15 watts.
If I put a fully charged battery in the mod it shows naturally 4.2volts on the screen, once I push the fire button the voltage dropps to 3.2volts.
Thats a drop of 1 volt.... I always was under the impression that anything from 0.3 to 0.5 is normal....
Well, how can I improve this?
Thanks
Alex