VTR owners
- Thread starter My Name Is Treetop
- Start date
- th_trl_thread_readers 0
- Status
3.6 volts and 5.5-6.5 watts seems to be the sweet spot for the liquid I use. Pink Spot products mostly. They're so light you don't need to crank the voltage up
Last edited:
How do you fill the tank that comes with the VTR? Take off the drip tip, pour into there?
Unscrew the drip tip, then unscrew the top cap. Pour juice in the tank beside the head. Screw top cap back on, screw drip tip back on, then let the tank sit for at least 10 minutes. Then vape away.
I dont run wattage much. doesnt work great for dual coils.
but I run my iclear 30s at 4.6v, vapes like a beast and is fantastic... other than the incredible juice consumption. dear lord all the juice I go through D;
but I run my iclear 30s at 4.6v, vapes like a beast and is fantastic... other than the incredible juice consumption. dear lord all the juice I go through D;
Maybe should have been mentioned also... The low figures are usually for stock coils. I should have said that earlier. If I use the coils I build, I am finding they like more about 8 watts. The higher wattage coils I build are 1.5 microcoils with cotton wick.
I typically vape on house juices from my local brick and mortar. 70 PG/30 VG
My iClear 30s is topped up with Coffee, and a 1.9 ohm head, vaping at 10.5 watts. 11+ and it runs dry on the end of a good pull.
My Protank2 has Blueberry Waffles, and currently a 2 ohm head, vaping at 12.5 watts, flavor goes south past that. I have a spare base, and I'm going to experiment with some microcoils on the VTR. I'd like to get down to 1.2 ohms, which at full 15 watts should keep it down under voltage and current limits. Hell, on paper, this thing should fire a .6 at 15 watts, and be right on the edge of current limitations. Not going down that far on a PT2, though.
My iClear 30s is topped up with Coffee, and a 1.9 ohm head, vaping at 10.5 watts. 11+ and it runs dry on the end of a good pull.
My Protank2 has Blueberry Waffles, and currently a 2 ohm head, vaping at 12.5 watts, flavor goes south past that. I have a spare base, and I'm going to experiment with some microcoils on the VTR. I'd like to get down to 1.2 ohms, which at full 15 watts should keep it down under voltage and current limits. Hell, on paper, this thing should fire a .6 at 15 watts, and be right on the edge of current limitations. Not going down that far on a PT2, though.
I'm running my new KF coil build (1.4 single micro coil, cotton) at 11 watts right now on a 50/50 (PG/VG) banana vanilla from the local B&M. It rocks!
Just wrapped a microcoil for the PT2. 10 turns of 28g kanthal came out to 1.3 ohms. Wicked with cotton; good flavor, great vapor, and surprisingly cool at 15 watts. 3.4 amps, well under the device limits.
- Status
Similar threads
