Waiting for #2 and couldn't wait anymore

[tmel]

Finally built my BF Mad Modz Reactor, it's the smallest RDA that I've seen. The post holes are drilled to fit dual 24G and I have a 3/32 and 5/64 cap.

Rocking some Boba's/GJ for the first time and im in love with it! The flavor is better then the RM2 and I can't wait to get an LP to use this on!

I had to go with vertical coils and it took about 5 tries to finally get this working, with it being so tiny it was very hard to get the coils positioned on the deck properly without causing a short. I had to do a slight lean and got them both of the center post.

Wicked it from the top down and tucked the bottom tail under the coil and the top tail is mashed against the side of the coil. I left behind the coil open as the atty feeds from a slotted 510 and insulator, hope it'll squonk well and I won't have to rebuild these coils for 3+ months, lol.

7 wraps 24G @ 5/64 ID, no idea what the ohms are, but I imagine in the 0.4 - 0.5 range.






Lost my open center post 510 to 510, so can't use on my regular grand and yes it leaks a little out the bottom.

 

[Filthy-Beast]

Very interesting congrats, that does look tiny.

 

[tmel]

Thanks, its a very warm and flavorful vape..3 second drags, 3 drags and shes dry.

Found some liquid seeping onto my battery, so...thats all for now .

I know Rob says no adapters, but well...if it works, it works, right?

V2 510 Shorty Extension Sealed
510 to 510 adapter | extender

When I first got it, I used a connection from a broken ohm meter that had an open center post, it squonked great and looked funny. I hope the stealth one makes it just a tad smaller. (if it works at all)

 

[Filthy-Beast]

I think RTD sells a hollow adapter

 

[Filthy-Beast]

I think Rob is against them because it becomes much easier to over tighten and damage the 510, and in a drop would put a lot of stress on the 510 as well.

 

[tmel]

I think Rob is against them because it becomes much easier to over tighten and damage the 510, and in a drop would put a lot of stress on the 510 as well.

Ah, that makes sense...well, if I do drop it and jack the 510. I'll send it in to get that fixed and LP'd while i'm at it.

 

[tmel]

I think RTD sells a hollow adapter

They do! 510 to 510 Open Post Shorty - RTD vapor

 

[muzichead]

I never thought of running my coils almost vertical like that. How was the air flow? I have only used 28g and 27g in mine so far. The 27g setup was at .4Ω and was just a little too hot for my liking but the 28g is running at .6Ω and is a great vape for me. I have my coils on an angle right now but not as extreme as yours. Loving the Reactor V2. It has replaced all the rest of my collection at this point. Flavor is top notch and thick dense clouds to go with it.... Chowderhead is the man!!!

 

[tmel]

The air flow is amazing with the vertical coils like this, I really had to go vertical with the 24G, it was just too big of a coil to try to line up properly and itd be smashed up against the posts.

You should give the verts a try on your next build

 

[muzichead]

I will give it a try next time I coil it. Thanks tmel...