Wall Crawler Firing Bar Fell Off

[westhc]

I accidentally knocked the Wall Crawler of the counter onto a wood floor. Now I cannot get the firing bar to snap back on like I thought it would. I cannot tell if any little plastic bits broke off but did not find any on the floor.

Here are the pics of where it is now.

Yes, the firing bar cover really fits into the "slot". Not sure why the size looks so different in the pic.

I cannot tell if anything broke off in this pic - the best pic I could get.

Any thoughts on how I might fix this?

 

[untar]

Are those 2 dark plastic arms on the bottom of the mod spring loaded? In that case I'd think hooking the top of the switch in and then pushing the bottom hooks over those arms should work (maybe with the assistance of a toothpick).

 

[westhc]

Thx. The plastic arms on the bottom do not move at all - at least now they don't. The hook on the top of the cover slides easily into the slot in the body but I just cannot get the entire bar to snap into place.

 

[untar]

But those 2 black plastic arms are what's blocking the installation, right?
You may have to open that thing up to see how to get them out of the way and later back into place to lock the switch in position.

 

[westhc]

I am sure sure if the black plastic arms are blocking anything.
I put a rubber band around the bottom of the mod that holds the very bottom of the firing panel in place. That works fine. The firing bar depresses to fire and then pops back when released to stop firing.
Very stange.