Washing batteries??

Status
Not open for further replies.

GrimmGreen

Reviewer / Blogger
ECF Veteran
Jan 30, 2009
1,190
51
48
Carson City, Nevada, United States
i am also interested in this , i saw a youtube video of a guy that microwaved a small amount of vinegar i think , in a cup , and then put his batteries contact side down into the vinegar (it was only about 1/4 inch of vinegar) and let it sit over night. I guess the idea being that the fumes from the vinegar would clean out the juice from inside the battery. I have tons of dead batteries due to stuck switches and i was thinking of trying this. What do i have to loose? the batteries are already dead to begin with
 

Houdini

Ultra Member
ECF Veteran
Jan 12, 2009
2,107
39
65
Las Vegas
I'd recommend using this before water or vineger. I've used it on a good battery just to see if it would do any damage and the battery survived with no problems.

CRC_cleaner.jpg
 

sheik124

Senior Member
ECF Veteran
Oct 28, 2008
143
56
Tampa, FL
I had my battery and charger in a zip lock bag while traveling. My eliquid was in yet another zip lock bag, but I guess on the return trip I screwed up and put them in the same bag. Long story short, both battery and charger got eliquid all over them and inside them. I put them both in a plastic cup with some isopropyl alcohol, let them sit for about half an hour, and then swirled the cup around vigorously. I left them both in a paper plate in the sun to dry, with the charger also wrapped in a towel. After a day a nice small puddle of eliquid had leaked out of the battery, but I just charged it up and it seems fine. BTW, it's a DSE901 battery and the stock charger.
 

yoshistr

Senior Member
ECF Veteran
Jan 11, 2009
80
2
38
Long Island, NY
You can clean your batteries using the following quick guide I made:

1) Get a knife or sharp edged tool and gently pry the contact off the battery (you can see the rounded contact, put the edge underneath and pry upwards until it is removed) *Be careful as the contact is soldered to the battery so you don't want to completely remove it but only as far as the wire extends.

2) Place the battery with contact side on a piece of paper towel and let it dry and drain out overnight. (You can also consider sinking the contact side in vinegar/baking soda for a few minutes to clean it out, not too long because it may corrode the solder in which case you will need to resolder it)

3) Replace the contact back in the battery and use like new!
 
Status
Not open for further replies.

Users who are viewing this thread