What adapters needed

Status
Not open for further replies.

FallenRawToast

Ultra Member
ECF Veteran
Mar 30, 2014
1,995
1,929
LA, CA, USA, NA, SOL
Just a word of caution.

These adapters sometimes will cut off the air ports on the bottom, or be a bit too tall, or some other tiny little millimeter of a problem. So be prepared to have to possibly file the adapters down a little bit to make them work perfectly. They also sometimes do not reach far enough "down" to make contact with the battery post.
 

DaveOno

ECF Guru
ECF Veteran
Verified Member
Oct 27, 2013
12,763
23,616
Dutchess County, New York
I was looking into this same problem, but I found it much easier to just get a 510 threaded battery and a glass tank. (Heresy!!!)
I have my Tritons. Those tanks are the best flavor and vape. But I do like a cinnamon and other tank crackers.

And I'd get something like a 1300mAh Variable volt. So now I have the best of both worlds. The great vape of the Triton, and the ability to try any other tank without futsing around with adaptors. Plus another big battery.

Just my 2 cents.
 

FallenRawToast

Ultra Member
ECF Veteran
Mar 30, 2014
1,995
1,929
LA, CA, USA, NA, SOL
Yea. Still need advice on a glass tank where It's easy to get coils for

also what might be easy to get coils for us here.. might not be easy to get in Japan. Or you may find something in Japan that is far easier.

If you are looking for new gear, maybe take a look and see what you can find locally.
 

Shootist

Ultra Member
ECF Veteran
Verified Member
May 5, 2014
1,014
752
Decatur, GA, USA
Yea. Still need advice on a glass tank where It's easy to get coils for

Glass tanks/atomizers made by the top/major manufacturers, Aspire and Kanger, would be your best choice as the coil heads for either are readily available from many different dealers. But if you live in a remote part of the world where shipping is sometime a problem they will be equally hard to get.

In that case you might consider buying a Kayfun, wire, Kanthal, and cotton, organic, so you can build your own coils and wick them with cotton.
 

edyle

ECF Guru
ECF Veteran
Verified Member
Oct 23, 2013
14,199
7,195
Port-of-Spain, Trinidad & Tobago
Yea. Still need advice on a glass tank where It's easy to get coils for

miniprotank2v2
1640100-1.jpg

http://www.e-cigarette-forum.com/forum/blogs/edyle/6350-faq-1-what-tank-new-user.html
 

wheezal

Insane Halon
ECF Veteran
Aug 27, 2013
8,647
17,784
Austin, Tx
Just so there is NO confusion the above tank does NOT fit a Halo Triton Battery without an adaptor.

I know that is obvious to most, but just in case the OP didnt know.



i think that is kinda the point...i referred both posters here because they want to use their Halo batteries but have tank-cracking juices they enjoy.

so they came for advice on a good tank and adapter that would work for them.

knowing my fellow Halons like i do...i figured someone had done this before and could offer some help.


if we're concerned about talking about other suppliers merchandise, then simply PM the people asking for advise.
 

GreenLeaf

Vaping Master
ECF Veteran
Jun 11, 2013
7,432
7,632
Texas, USA
Sorry. Just to kinda close off the thread... there is just something i dont understand.

With those tanks, everytime i look at them, I cant seem to find the actual WICKS.... thats my issue... where do I get the WICKS

Halo uses 2mm Silica wicks. There are many sellers on ebay and amazon.

I'm looking into this myself, just can't decide on silica or the more expensive braided ekowool. There's also a cotton option.

After some research, it seems people are recommending pre-burning them with a flame/torch before installing.

I wish Halo would start selling their wicks by the foot.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread