I have not seen this and wonder what happens and if it happens with all e cigs. Thanks! 
What happens during the cleaning cycle?
- Thread starter QueenInNC
- Start date
- th_trl_thread_readers 0
- Status
After a certain number of puffs the light will start flashing and the circuit in the battery will turn the atomizer on full power to burn off anything that may be stuck to the coil. It only last 5 seconds or so. You can hear it sizzling too. This may promote early atomizer failure. When I see mine start to do it I unscrew the battery until it ends. I don't know if they all do it.
Thanks for the info and the tip! I will watch for this. I have heard about it but have not had it happen yet.
i thought it ran it for more like 20 secs, not 5, but maybe that depends on the model. it will burn the liquid, cart and atomizer. it supposedly leaves a burned taste for a long time, and even burns out the atomizers. i have been lucky and have gotten the battery off every time within a few seconds. the m-401 (evo and pilot) do not have cleaning cycles. not sure what other units if any besides that.i have mostly been using the pilot, so havent had to deal with a cleaning in a while...
It could be 20 but I let mine go without unscrewing it when I first got it and I could hear the sizzling for about 5-10 seconds at the most then it stopped blinking and didn't get any burned taste and the atomizer was fine after. I unscrew within a couple seconds too when it starts now.
And now that I think about it the light just stays on constant instead of flashing.
And now that I think about it the light just stays on constant instead of flashing.
Last edited:
I have not seen this and wonder what happens and if it happens with all e cigs. Thanks!
Queen--that dreaded battery cycle only spells bad news for the atomizer as it heats it so high that the mesh no longer will wick after it hits and it is only a matter of time before the atomizer fails--that is why the USB passthough is key for units that have batteries with a cleaning cycle.---Sun
Kiev--swap out batteries and if both do not work, you got a dud atomizer. Did you charge those batteries for 12 hours? Also could be a bad charger--does the Led light on the charger?--Sun
Kiev you need at least 8 hour charge, some go to 12.
About the cleaning cycle... after removing the battery it's a good idea to blow into the atomizer tube (from the cart end, after removing cart) to cool off the wick, at least if you've heard sizzling.
About the cleaning cycle... after removing the battery it's a good idea to blow into the atomizer tube (from the cart end, after removing cart) to cool off the wick, at least if you've heard sizzling.
Jamie, make sure your cart is filled. Then put two drops of fluid right on your atomizer. Take a primer puff prior to a smooth long drag to get it working. This should help.
Of course make sure your batts are strong.
Of course make sure your batts are strong.
I don't know where you are Kiev but this is the stuff - JANTY LIQUID - JantyShop
- Status
Similar threads
