What holds your mod(s) in the car?

[FringeChief68]

Dollar General, Half Off lol

View attachment 276842

It's made of Foam, Fits in a car cup holder it said it's for a Cell Phone.

 

[HDVaper]

Check THIS out.

 

[FringeChief68]

Check THIS out.

$68.00 For that much I would just pay someone to sit in my passenger seat and Hold my mod

 

[GunArm]

As a genny lover, I have to keep my mod more or less upright (which means cupholder by itself isn't suited). I went to home depot and got a 2" pipe coupling (the width of the cup holder) and a 2"-1" bushing to adapt it down to the width of my mod. It cost less than 4 bucks. Because I have a bottom-side button, I had to use dremel to take out the inner lip of the bushing (you can see this cut and smoothed on the inside of the top right image)
http://imgur.com/2vz4VKl
If I wanted it to look nicer I could paint it or something but it's very functional, I use it every time I'm in the car.


I've also heard you can buy one of those foam pool noodles with the hole down the center and cut a few-inch section of it off, supposedly they are the right width for a cupholder on the outside and for a mod on the inside.

 

[Mark Anthony]

My hand or my jackets inside pocket.

 

[CommaHolly]

my hand,,,,,,,,,if I MUST put it down, it goes in the passenger seat,,,,,or into the lap of the person sitting in the passenger seat if the front passenger seat is occupied.

 

[Jonibrasco]

I use this. The Cup Vape by CraniYums

Sent from my SPH-L900 using Tapatalk 2

 

[EddardinWinter]

This. It is a nice little plastic holder I picked up at VaperCon for like $12 or something.

Pretty nice, and I can bring it in wherever I am going to have a mobile stand for my mods. I like the little juice holder for my drippers, too. Not that I would ever drip and drive. Well, maybe when I am stopped at a light...

 

[kazimir]

I just have a koozie in the cup holder. The car has a double cup holder with a gap between the 2 sections so can't stay upright without some form of a stop.

 

[Danbrooks2k]

cup holder... cartos in what used to be the ashtray... lol

 

[Danbrooks2k]

Dollar General, Half Off lol

View attachment 276842

It's made of Foam, Fits in a car cup holder it said it's for a Cell Phone.

I love the dollar store... I am so getting one and then telling everyone I came up with the idea... YOINK!!!

 

[KurrptSenate]

my coat has 2 inside pockets, one on each side. my provari fits nicely in the left side so that's where i tend to carry it.

 

[Hill]

In the ashtray of course.
Fortunately mine is located in such a way as to hold my PVs more or less upright. (Genny friendly)

 

[nicetucu]

I just use my cup holder and if that is full of drinks just use a rectangular spot next to the shifter and lay it on its side.

 

[basylica]

here is the rental I got in alabama.....PV friendly!!

 

[Danbrooks2k]

Coffee cup, soda, vape gear... purrrrrrrrr! Caffeine and nicotine... yusss!

Daddy Likes!

 

[basylica]

Coffee cup, soda, vape gear... purrrrrrrrr! Caffeine and nicotine... yusss!

Daddy Likes!

LOL....well the coffee was earlier, but it was bloody hot in bham and they turn the AC off in the office over the weekend and I was DYING it was so stuffy. I had to go outside to catch my breath. So the cups were water + a orange julius which I hadn't had in YEARS but since it was icy it was nice.

I can't travel sans water....even before I started vaping

 

[bigmaaark]

in my car there is a little triangular spot by the cup holders. a bottle of liquid and my mod fit perfect in there. or i just hold it

 

[Myrany]

here is the rental I got in alabama.....PV friendly!!View attachment 276942

hahaha is that a Pontiac Vibe? It looks exactly like the setup in my car. The square hole is where my cell phone goes.

 

[basylica]

hahaha is that a Pontiac Vibe? It looks exactly like the setup in my car. The square hole is where my cell phone goes.

It was several months ago and i had the car for 24hrs but i think it was a elantra...