- Status
My experience with factory coils was that you can't use them anywhere near their rating if you want to get a decent life out of them.
Just a comment about your title... Mods don't spit/crackle ect (the "mod" is the battery part) it's the tank ("atomizer") just wanted to clear up the terminology for you.
Don't you get a lot of leaking when you use them much below their rating? That seems to happen for me.
Flooding for sure and maybe spit back that will end up in leaking ofc....but depends how u vape...
If u puf veeeery lightly and veeeery slowly long draws it could work...but that depends on the coil and atomizer ofc also...
I always try work my coils Soo I can hear they make a nice popping sound and not like boiling sound
aaaaaaaaaanywaysssssThis first ^^.
Might seem counter-intuitive, but sometimes firing a coil at too low a temperature will cause it to sputter and spit instead of instantly and fully vaporize your eliquid. Try going up in maybe 5 watt increments until the vape smooths (smoothes?) out or until you hit the stated max watts for your coil.
Just my
.
Usually the result of this is either there not being enough cotton in your wicking ports this causing the juice too over saturate your cotton and over your coil causing a spit back of juice when vaping on it , or your coil is too close to your mouthpiece and not the buildeck , or the inner diameter of the coil is too small to accommodate enough cotton to fill your wicking ports.
So try the following :
Rewick vape and make sure the wicking ports are filled just enough , also make sure that the coil is not too close to your mouthpiece if so cut it shorter and lower it closer to the build deck.
If it's still a problem then replace coil for one with a bigger diameter in the middle
Hope this was useful
Agree with others. Only time I get spitting and burned tongue is when I don't use enough wicking.
- Status
Similar threads
