What Voltage do you Vape with?

[tayone415]

I have a Vision Spinner that goes between 3.3V to 4.8V and an Ego V that goes between 3V to 6V. I have single and dual coil clearmomizers. I noticed with some of my clearomizers using the Ego V vaping at 5-6V just taste burnt. Just trying to figure out what's other people's opinions and preferences are and why.

 

[hvac999]

If I am using my vv Gripper I am normally around 4.5v.

 

[Ryedan]

Using clearos of average ohms I am usually around 3.7 volts. Cartos come in higher without burning. rba's, well it all depends on the way you set them up. Some juices I keep lower and some I go higher with in all devices. HTH.

 

[LT Smok]

For me it depends on the accessory I am using

My IGO-L is 4.2V @ 10 watts with a 2.2ohm coil

Puritank is 4.0V @ 6.5 watts with 2.2 ohm head

My cartotank is 4.0V @ 6 watts with a 1.7 ohm prepunched 2 hole single coil ( Just got some dual coils gonna have to test them)

 

[Bill's Magic Vapor]

About 7.0 - 7.5 Watts. So, voltage depends on Ohms. Use calculator to determine voltage (Add Wattage and Ohms/Resistance and select calculate. Set device for calculated voltage:

Watts - volts - amps - ohms conversion calculator

 

[supersxyfuntime]

Z-Atty U at about .4 Ohms running off of 4.2 volts generating about 44 watts. Vapes like a beast

 

[Jonny5]

I focus on watts. Usually between 7-8

 

[Fizzpop]

Depends on the resistance of my coil. I aim for 6 Watts and then do the math.

 

[DavidOck]

Whatever voltage gives you the flavor you want. And it may be different with different juices.

That's the only "rule" I follow, although the voltage = double the resistance does provide a reasonable starting point for adjustment.

 

[Txaggiesaunt]

If it taste burnt, turn it down. I always adjust mine by taste. Start low and turn up till you hit your sweet spot

 

[JmanEspresso]

Its dictated by the resistance of the delivery device and the juice being used.

right now Ive got an EVOD which is 2.5ohms, and Im running 5.3volts. To be honest, thats higher than usual for me, but the juice tastes great at that voltage, so thats where Im at.

Its all about flavor for me. There is a general range of acceptable voltages depending on the resistance, but I adjust within that range based on flavor. Also try to balance the throat hit into the equation. If I can get more throat hit by going a little higher, and still not ruin the flavor, than I will do so. I value throat hit about as much as I value flavor, because without TH, the flavor would have to be orgasmic to make it worthwhile to vape. For me.

 

[tj99959]

You have three controlling factors voltage, resistance, and air flow that all work in harmony. Changing one of the three normally requires changing one or both of the other two. So there really isn't a one shoe fits all answer to that question.
IMO, the best answer is to just adjust to taste, and don't worry so much about what voltage is best.

Right now my VV PV is set at 3.9v, and my mechanical ... well ... it is whatever it is. When it no longer tastes the way I want, I'll swap out the battery.

 

[tayone415]

About 7.0 - 7.5 Watts. So, voltage depends on Ohms. Use calculator to determine voltage (Add Wattage and Ohms/Resistance and select calculate. Set device for calculated voltage:

Watts - volts - amps - ohms conversion calculator

Both my vaporizers only show me volts and I normally use the iclear 30 that I think is 2.1 ohms.

 

[BlueMoods]

Depends on the juice in my protanks. anything form 3.5 to 6 is my range for the juices I use regularly. In general sweeter and darker goes lower than pale to clear and not sweet juice.

 

[retired1]

Both my vaporizers only show me volts and I normally use the iclear 30 that I think is 2.1 ohms.

You should be starting off at around 4 volts and then adjust upwards or downwards accordingly (depending on the juice and taste). Cranking it all the way up to 6 volts will definitely give you that burnt taste.

 

[tayone415]

Depends on the juice in my protanks. anything form 3.5 to 6 is my range for the juices I use regularly. In general sweeter and darker goes lower than pale to clear and not sweet juice.

I have noticed that, and usually the darker juices I've gotten were thicker and lasted longer. I actually had a 10ml bottle last me 7 days and some hours instead of my normal 2.5 to 4 days tops.

 

[tayone415]

You should be starting off at around 4 volts and then adjust upwards or downwards accordingly (depending on the juice and taste). Cranking it all the way up to 6 volts will definitely give you that burnt taste.

Yeah, all my clearomizers taste burnt on 6v except for my iclear 30, but looks too big on both my vision spinner and especially with my ego v but the collar makes it look less awkward. Just feels really top heavy.

 

[retired1]

A quick rule of thumb regarding setting the voltage. Take the resistance of your head (say it's 2 ohm). Add 2 to that to get your initial voltage (4 volts). Vape. Adjust your power upwards or downwards according to taste. Once you find your sweet spot, enjoy.

 

[Jim Diamond]

What voltage do we vape with? Is this a clever way of asking, "how big is your battery?"

 

[retic1959]

4.2 volts with 2.5 ohms