What voltage do you vape?

[Johnny2puffs]

I vape 70/30 PG/VG juice and if I go over 4v then I get the burned taste. Tried some different flavors and "no name mixes" and still cannot go over 4v.
At 3 to 3.5v I get a good TH and plumes of vapor with 2 to 2.5 ohm single coils.
I have 2 LT's and both do the same. Is it just me and my pallet or is this normal with the LT?

 

[ChrispyCritter]

3.7-4.2v mostly with my 2.5ohm CE2's in tanks..I'm running at 4.4v with my drip on demand and a homemade atomizers out of CE2 parts with Carmel Tobacco as I type this..one flavor that I don't vape often (coffee) around 3.3-3.5v because it's harsh if I do but it's not in a tank just a CE2 clearomizer 2.5ohm and usually I use it on my mega auto 510 battery. Sometimes I go up to 5v when my cartomizer seems to be getting gunked up to burn some off so it lasts a bit longer before I clean it. It really depends on the juice, ohms, the kind of carto/atomizer and personal preference...

 

[Mainspring]

around 3.7 to 4.5 with 2.5 ohm, depending on the juice.

tons of vapor, good throat hit, lively flavor.

 

[Sedateme]

Single coil cartos and LR atty's I vape at 4.2-4.4 volts. Dual coil cartos I vape at around 5.5 volts. I like it nice and hot =)

 

[MrWarspite]

Juice matters a lot here. I mainly vape KBV's juices and some of their's taste great at 3.7 on a 2 ohm and lose flavor above 4 while others are best at 4.7v. Every juice is different, which is the beauty of the lava/vari tube.

 

[jamiroquai]

Depends on the atomizers, if i use a cisco 1,5 i vape with 3,6 - 3,8
If i use the iatty i need more power, like up to 4 !
allways on the ProVari

 

[SilentEcho13]

4.1v with my standard resistance CE2's

5-5.2v with my 2.5ohm bridgeless/wickless 306 atty.

 

[Johnny2puffs]

Just tried today. 3v with a Single Coil 1.6ohm carto and to get the same hit and vapor as with a dual coil of 1.6 ohm, I have to up the volts to 6v.
Just trying to get my supplier to understand that his 1.6ohm cartos are NOT Dual Coils as I can't go over 3.2v with them as the juice then burns. So they must be Single Coils.

 

[7spokenightmare]

to those running low resistance and dual coil...... i thought the lavatube pulled the voltage down to 3.7 no matter what you set it at if youre using low resistance (or dual coil).... at least thats what ive managed to figure out from all ive read....

 

[Johnny2puffs]

to those running low resistance and dual coil...... i thought the lavatube pulled the voltage down to 3.7 no matter what you set it at if youre using low resistance (or dual coil).... at least thats what ive managed to figure out from all ive read....

Correct. If you using 1.5ohm then you cannot go over 3.7v. DC or SC otherwise you exceeding the 2.5A max. My choice would be 2ohm SC as it gives you a wider range of voltages to choose your sweet spot.

 

[Tiesel]

I usually vape at 3.7 to 4.7, I have this one atty though, it just will not fire unless its at 4.8 or higher. I use it for dripping and all is good, it just likes the high volts. Its sister attys that came with are all normal, they vape well at any voltage. It really depends on my juice, with a few like MBV's Extreme Ice I sometimes crank it up to 6v but its a low 12mg nic.

 

[PapaD34]

I played around with my Lava Tube for a while looking for the best voltage for me. What I came up with is 4.2V-4,5V. It does not matter what flavor I am vaping or the mix (I like 70/30) 4.2V-4.5 seems to be the best for me.

 

[hairball]

3ohm boge at 6V...sadly doesn't work on the LT. That's the biggest reason I don't promote it.

 

[stuvix]

I just got mine yesterday. I love it! I'm not sure the resistance of my atty, I'm using the one that came with it - which isn't too bad. So far, with my 30/70 PG/VG juice it seems pretty good around 4.0v. Anything above 4.5v is too harsh for me. I vape a lot, constantly in my waking hours. Because of this, the flavour (from my old eGo-C) would disappear after about an hour from waking up. Now, if the flavour changes, I just either ramp the voltage up or down and I'm able to get the flavour I want. Awesome

 

[invididual]

3.0 oHm @ 4.3v but Ive really only vaped the RY4 so far, dont have any other 3.0 oHm anything to try other flavors in, anxiously awaiting my 3.0 Boges from VaporBeast

 

[WA3PNT]

I found this chart to be most helpful in selecting the "best" voltage. I was too high, and my batttery life has improved greatly when I moved to the green area.

http://img.photobucket.com/albums/v202/trinitrophenol/unled66-1.jpg

RodeoGeorge

 

[KeysBum]

Voltage varies depending on carto resistance. Generally between 8 and 9 watts.