Where is this leakage from my Vision Clearomizer coming from?!

[jcp42877]

So I've noticed on my clearo, that the see-through housing section of the piece is lightly moist with some juice on the outside constantly. I checked between the battery and the bottom and its not wet at all, and there's not a leak or opening near the drip tip.

Could it be possible it's leaking out above the chrome "collar" piece that's ughh below the mL gauge? Or, has anyone else noticed this as a potential spot?

I don't see any hairline crack in the clear part, so I'm baffled. If there is a leak, I'm thinking of just putting some duct tape around it until my new clearo comes in.

 

[in4mati0n11]

I'm thinking of just putting some duct tape around it until my new clearo comes in.

LMFAO!! necessity is the mother of all invention... A little 100mph tape will fix just about anything!

 

[brillyntdisguise]

I had the same issue and then realized that some e-juice was getting on the inside of the rim and when I pushed the thingie (sorry don't know what it's called) back on, it was forcing that liquid out. I just wipe it down after filling it and it solves the problem. Also, if I use a dropper instead of dripping it right out of the bottle, I am able to get it down beside the swab thingie (again, sorry...I don't know what it's called, either) and the leakage doesn't happen. Try to notice if it is happening when you screw the black tip back on your clearomizer.

So I've noticed on my clearo, that the see-through housing section of the piece is lightly moist with some juice on the outside constantly. I checked between the battery and the bottom and its not wet at all, and there's not a leak or opening near the drip tip.

Could it be possible it's leaking out above the chrome "collar" piece that's ughh below the mL gauge? Or, has anyone else noticed this as a potential spot?

I don't see any hairline crack in the clear part, so I'm baffled. If there is a leak, I'm thinking of just putting some duct tape around it until my new clearo comes in.

 

[in4mati0n11]

a guy showed me a trick using a metal tooth pic to raise the little silicone piece back up so the tip seals...fwiw

 

[justinred]

^^ +1 on that. I use a paper clip with an itty bitty bend at the tip. Removing o-ring in the drip tip will also work as tip will push in deeper for a better seal. Don't worry about leaks after removing o-ring as it has anothe seal at the collar.