Where to solder the voltage display?

[Jesper]

Hi guys

I'm trying to finish my first VV mod with a voltage display, but I'm in a little doubt as to where to solder it to.

I'm using the VV Regulator Kit from madvapes and the Battery Voltage Indicator also from madvapes.

Thanks

 

[retird]

Normally you solder the ground (-) pin of the indicator to the a battery ground, and the positive pin of the indicator (+)to the positive wire going from the push button switch to the atomizer connector (center pin)..

 

[Jesper]

Thanks for your reply.

However I just tried that, and when I switch on the box, the display reads the total voltage of the batteries and not the regulated voltage, and the display is turned on all the time and not just when the push button is being pushed.

 

[hoogie76]

just to clarify, positive lead of the voltage indicator would be connected to pin 4 of the regulator board and the gnd can go anywhere but pin 3 works also.. Does the mod appear to work okay and just the indicator stay on all the time?

hoog

 

[Jesper]

@hoogie76 Yup, everything is working fine besides the display. However I fixed the issue, I put it across the atomizer connector and it's working now

Thanks for the suggestions guys